Countertops

Width 30" | Height 34.5" | Depth 24"

3 drawer base cabinet.

Width 29" | Height 2.875" | Depth 21"

Roll out tray to be used with a 33" wide base cabinet. The roll out tray will come pre-assembled, dovetailed, and have a soft close full extension track. They are solid birch with a natural maple finish. *Please note this roll out tray will only work with this collection*

Width 3" | Height 84" | Depth 0.75"

Wall filler. Commonly used to fill gaps between cabinets and gaps between cabinets and appliances.

Width 54" | Height 6" | Depth

Valance that can be trimmed up to 6" on either side.

Width 4" | Height 96" | Depth -

Crown molding that comes in an 8 foot strip. Commonly used to finish the top of wall cabinets.

Width 3" | Height 34.5" | Depth 3"

Decorative leg with that comes with a wall filler.

Width 24" | Height 18" | Depth 12"

Small 2 door wall cabinet. This cabinet does not have a center stile or shelves. This cabinet is commonly placed above the range, refrigerators, wine racks, plate racks, or above the sink (if no window is present), it can also be utilized in other areas.

Width 24" | Height 42" | Depth 12"

Wall diagonal corner cabinet that takes up 24" from the corner out, on each wall. This cabinet comes with 3 shelves.

Glass door for a corner wall cabinet that is 24" wide and 30" high (actual glass door measurements are 14 15/16W" x 29 5/16H"). Frosted glass is included. The actual cabinet must be purchased separately.

Width 24" | Height 84" | Depth 24"

Wall pantry cabinet that has 4 doors, 2 smaller doors on top and 2 larger doors on bottom. This pantry cabinet comes with 1 fixed shelf and 3 adjustable shelves. There is no center stile. Measurements are as follows: Top/Middle/Bottom door width = 11 11/16". Top door height = 29 5/16". Middle/Bottom door height = 49 1/4". There will be a horizontal decorative stile across the bottom pantry doors.

Decorative panel for the side of a 24" deep by 96" high cabinet or accessory (pantry cabinet, oven cabinet, refrigerator panel, etc...). Comes as a 2 piece door set.

**The door will not get installed behind the face frame, it will be installed onto the frame. Then, 1/4" shims would be used on the opposite side so it's leveled.**

Width 30" | Height 96" | Depth 0.75"

Refrigerator panel that has a 3" return. This panel will be finished on both sides and if the return is removed, the front edge is also finished.