Cambridge Saddle Glaze - Limited Stock

Width 3" | Height 96" | Depth .75"

3"x96" Filler.

Width 3" | Height 96" | Depth .75"

3"x96" Fluted filler. Can be trimmed to different heights to create wall or base fluted fillers.

Width 42" | Height 34-1/2" | Depth 24"

2 door base cabinet that has 1 half depth adjustable shelf and 2 drawers. This cabinet does have a center stile and will not have butt doors.

Width 39" | Height 34.5" | Depth 24"

1 door blind base corner cabinet that takes up a minimum of 42 1/2" of wall space and can be pulled up to 49". The actual cabinet width is 39" and has a minimum pull of 3 1/2" and a maximum pull of 10" from the corner. This cabinet has 1 drawer and is reversible. The door measurements are 15 7/8W x 22 1/2H x 3/4D. The drawer front measurements are 15 3/4W x 6 1/4H x 3/4D. The drawer box is 12 3/8W x 3 3/8H x 20 3/8D and the door opening is 12 3/4"W x 20 1/2"H. The stile between the door opening and blind opening is 10" wide. A filler must be installed between the blind cabinet and the adjacent wall cabinet (so it's perpendicular to the blind cabinet).

Width 11.5" | Height 41" | Depth .75"

Wall decorative end panel.

*The door will not get installed behind the face frame, it will be installed onto the frame. Then, 1/4" shims would be used on the opposite side so it's leveled. As an alternative, a 1/4" skin can be purchased instead and installed first, then the decorative door can install directly on the skin.*

Width 42" | Height 96" | Depth .25"

Bead board finished panel (only finished on one side).

Width 42" | Height 96" | Depth .25"

Finished veneered panel, finished on one side.

Width 48" | Height 4-1/2"

Arched valance that can be trimmed down to needed size. It will be 4-1/2" high at the tallest points on the ends of the valance.

Width 48" | Height 6" | Depth .75"

Shaker arched valance. The height in the middle of the valance is 3".

Width 6" | Height 42" | Depth .75"

6"x42" Filler.

Width 6" | Height 96" | Depth .75"

6"x96" Filler.

Width 96" | Height 4.9375" | Depth .75"

Base molding. Please note this base molding is slightly taller to account for uneven flooring and may need to have the height cut if needed, on site.