Rustic Shaker

Width 60" | Height 34.5" | Depth 21"

Vanity combination cabinet that has 2 sets of doors on either side of the cabinet, 3 drawers in the middle, and a fake drawer front on top of each set of doors. The top drawer is standard sized and the bottom 2 drawers are deep drawers. The 3 middle drawers are fully functioning and there are no shelves.

Width 36" | Height 24" | Depth 24"

Wall refrigerator cabinet that has 2 doors and 1 adjustable, full depth shelf.

Width 30" | Height 15" | Depth -

Plate rack that holds 10 plates and can also be installed under a shorter wall cabinet.

Width 24" | Height 96" | Depth -

Refrigerator end panel that has a 1/2" thick panel with a 1-1/2"W filler on the front. This refrigerator end panel can be trimmed to desired height and may be used either left or right. This panel comes finished on both sides.

Width 30" | Height 23.5" | Depth 8"

Range hood front that must be installed between 2 cabinets for support. Before installation of the range hood front, the blower should be installed and the depth adjusted using fillers and/or panels to fit the blower. The sides will be pre-finished to match.

Width 36" | Height 23.5" | Depth 8"

Range hood front that must be installed between 2 cabinets for support. Before installation of the range hood front, the blower should be installed and the depth adjusted using fillers and/or panels to fit the blower. The sides will be pre-finished to match.

Width 96" | Height 9/16" | Depth .25"

Rope insert for crown molding (LCM8) that comes in 8 ft long sections. There is a flat section on the crown to accommodate the rope insert installation. If it seems the rope insert will not attach properly, make sure the crown is not upside down.

Width 33" | Height 34.5" | Depth 24"

Sink base cabinet that has no shelves or drawers.

Width 36" | Height 34.5" | Depth 24"

Sink base cabinet that has no shelves or drawers.

Width 3" | Height 42" | Depth 1.375

Split corner decorative leg that is 3" wide, 42" high and 1-3/8" deep. The top flat section is 7" high and the bottom flat section is 7-1/4" high.

Width 30" | Height - | Depth 12"

Stem glass holder that is made of solid wood and mounts to the bottom of a wall cabinet and can be cut to fit smaller cabinets. It will hold 6 rows of glasses (if full 30" width is used). Once installed, it hangs down 1.75". This product ships pre-assembled.

Width 96" | Height .75" | Depth .25"

Shoe molding that can be trimmed to desired height and/or width.