Milan White Matte

Width 48" | Height 96" | Depth 3/4"

Back panel that has one finished side. All edges and opposite side will be unfinished. There will be no edge banding but edge banding can be ordered and applied on site, if needed.

Width 13-7/8" | Height 96" | Depth 3"

Refrigerator end panel that is finished on both sides and edgebanded on all edges. The panel has a 3" filler attached to the front which will be flush with the sides.

Width 24-7/8" | Height 96" | Depth 3/4"

Refrigerator end panel that is finished on both sides and edgebanded on all edges.

Width 25-7/8" | Height 96" | Depth 3"

Refrigerator end panel that is finished on both sides and edgebanded on all edges. The panel has a 3" filler attached to the front which will be flush with the sides.

Width 30" | Height 96" | Depth 3/4"

Refrigerator end panel that is finished on both sides and edgebanded on all edges.

Width 30" | Height 96" | Depth 3"

Refrigerator end panel that is finished on both sides and edgebanded on all edges. The panel has a 3" filler attached to the front which will be flush with the sides.

Width 21-7/8" | Height 34-1/2" | Depth 3/4"

Vanity base end panel that is finished on two sides and edge-banded on all four edges.

Width 3" | Height 30" | Depth 13-7/8"

Wall end panel with a filler attached to the front that will be finished on two sides and edge-banded on all four edges. The filler on the front will be flush with the side and can be cut down if needed. If it is cut, to avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off).

Width 3" | Height 36" | Depth 13-7/8"

Wall end panel with a filler attached to the front that will be finished on two sides and edge-banded on all four edges. The filler on the front will be flush with the side and can be cut down if needed. If it is cut, to avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off).

Width 3" | Height 42" | Depth 13-7/8"

Wall end panel with a filler attached to the front that will be finished on two sides and edge-banded on all four edges. The filler on the front will be flush with the side and can be cut down if needed. If it is cut, to avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off).

White plastic tilt out tray which can be used in a diagonal sink front (DSF36 or DSF42), or a 27" sink base or vanity sink base (SB27 or VSB27). If using with a 42" diagonal sink front (DSF42), SB27 or VSB27, 2 trays will need to be ordered).

White plastic tilt out tray which can be used in the following sink bases or vanity sink bases: SB21, SB24, SB24SD, SB33, SB36, VSB24, VSB24SD, VSB33, VSB36. If using with a 33" or 36" sink base or vanity sink base (SB33, SB36, VSB33 or VSB36), 2 trays will need to be ordered).